alt

AguedaCleland57

On Our Car Radio Setup PageWe Prove You Tips And Tricks

Rate this Entry
In Audi, Volkswagen and Opel, the pin assignment of permanent and shifting plus is frequently reversed. In order for your new car radio to operate properly, you must change the pin assignment. To do so, replace the pins 4 using pin 7 on the ISO power plug. To switch from the old 150 ohm antenna inputsignal, also called DIN, to some 50 ohm ISO antenna connection, you need a suitable adapter, like this one for example.

The way to remove the old car stereo. Before you can set up the new car radio, you need to get rid of the old radio.

To find the radio from the slot, you need special release pins. These are usually included. If you do not have suitable pins on hand, it is also possible to ask a workshop to lend you the specific terminals for a short moment. To unlock the radio, slide the pins and right into the slots / holes provided.

The way to install the new car radio. The installation of a new automobile radio is not difficult, provided that you make sure all connections fit and the form factor (1-DIN or 2-DIN) fits. If that is not the case, you could also be able to help with a suitable adapter. Here is how it works: Insert the new mounting framework. This is necessary since these frames are normally not compatible with different radios. If you liked this information and you would certainly such as to get more details relating to Autoradio Einbauhilfe kindly go to our website. Bend the metal tabs so that the frame is firmly in the car. This is particularly important when you wish to be certain that later on no one can simply remove the car radio from your vehicle.

Before you begin to install your radio, you should read the installation instructions in the guide well. Pay special attention to the recommended instrument. Because in the event that you've already started with the installation and then determines that an important special tool is missing, that's more than bothersome. Some radios may be installed using standard tools such as a luster terminal, pliers and screwdrivers.

Small plug and cable customer. Each car radio has two kinds of connections: inputs and outputs. The inputs include, for instance, the power supply. The outputs include the links for speakers. If you are not certain, you can attach modest labels to the cables. The way to find your way about later. In order to be able to wire your new wireless, you should get in this situation a set of adapter plugs. Another point is the power supply of this antenna amplifier.

Now carefully pull on the tool. The old car radio is currently falling out of control. Gradually pull the radio from the center console, taking extra care not to tear any plugs. Then disconnect all links from the old radio. Don't ruin them, as they will want the cables . Take now a flat screwdriver to hand and eliminate the mounting frame of the older car radio from the tray. To do this, fold all of the metal tabs so that you can then remove the frame.
دسته بندی ها
Uncategorized

Comments